Foam in water fountains can be a problem if you have undissolved organics in your water.  Typically, foam is simple to get rid of with Foam-Nix Defoamer.  This fountain care product is great for table top and other indoor fountains and outdoor patio ponds or fountains.  It will eliminate foam in your fountains fast and it is safe for fish, plants and wildlife.  You may also see an occurrence of foam if your fountain is located in direct sunlight as undissolved organics may be higher than normal due to faster evaporation rates. Foam-Nix gets rid of unsightly foam fast, leaving the water clean and clear.

Keep your fountain looking great.  Delays and helps prevent fiberglass or resin fountains from peeling or fading. 

Sometimes outdoor fountains can fade or peel in certain situations such as extreme heat, direct sunlight, chemicals in city water, or even salty sea air, therefore, as a precaution, we suggest this sealer/finisher specifically for fiberglass or resin materials.  This acrylic spray will keep your fountain looking great.  It guarantees to delay and perhaps even prevent fiberglass or resin fountains from peeling or fading.

Application:

1.      Open can and shake vigorously for 30 seconds

2.      Spray evenly over fountain, focusing on the parts where the water sits or flows.

3.      Wait 10 minutes, and then spray it again.

4.      One can should be able to seal up to an 80 inch tall fountain with two coats.

5.      Spray once every 6-12 months.

6.      Colors are intensified and given a matte finish with every application.

7.      Seals as a clear, protective, non-yellowing, weatherproof coating which provides permanent protection  

         for all painted finishes.